NENO Beauty Luve

Neno Beauty Luve is a 4-in-1 multifunctional device with five intensity levels, giving you full control over your daily beauty routine. Using microcurrents, EMS, electroporation, sonic vibrations, and four colours of LED light, it supports regeneration while firming, smoothing, and brightening your skin. The built-in timer and skin contact sensor ensure safety, and the compact design allows you to enjoy salon-quality results in the comfort of your own home. Each mode offers 5 intensity levels, allowing you to customise your treatment. Start at the lowest level and gradually increase it over weeks of use. For sensitive areas (eyes, nose, lips), always use the lowest level.

Electroporation

Electroporation is an advanced, non-invasive technology that uses short electrical pulses to increase the permeability of skin cell membranes. This allows the active ingredients in cosmetics to penetrate into the deeper layers, which significantly increases the effectiveness of your skincare. With Neno Beauty Luve, electroporation is now available not only in salons but also for at-home care.

EMS Technology

EMS is the most intensive form of microcurrent stimulation used in the Neno Beauty Luve. It acts as a workout for your facial muscles, helping to maintain their natural tone and supporting skin elasticity. Regular use brings the best results depending on the skin's predispositions. EMS promotes firmness, elasticity, and improved facial contours.

Sonic Vibrations and AIR SHOT Mode

Neno Beauty Luve uses sonic vibrations tailored to each skincare mode, ensuring effective and comprehensive support for your daily care. Special vibration patterns improve the absorption of ingredients, enhance facial contours, and increase skin firmness and elasticity. The Air Shot mode combines blue LED light, micro-pulses, and short-wave vibrations. It reduces imperfections and improves skin texture. It may cause a slight tingling sensation or a faint smell of burnt fine hairs – this is normal and safe.

Booster, MC and Derma Shot Modes

Combines yellow LED light, vibrations, and electroporation to promote deeper absorption of active ingredients. It increases skincare efficacy, improves blood circulation, and evens out skin tone. Use with gel or water-based cosmetics rich in active ingredients (hyaluronic acid, peptides, niacinamide, ceramides). A tingling sensation may occur – this is a natural phenomenon. MC combines green LED light, vibrations, and microcurrents. It stimulates collagen, improves firmness, and reduces fine lines. A tingling sensation may occur – this is a normal reaction to the stimulation. Derma Shot combines red LED light, vibrations, and EMS. It firms the muscles, tones the skin, and improves facial contours. It may cause gentle twitching or tingling – a natural result of the impulses.

Massage instructions:
AIR SHOT – Use the edge or tip of the head, not the entire surface. BOOSTER – Apply to the entire head in circular motions (from the centre of the face outwards). Always use with a lightweight gel-based skincare product rich in active ingredients. If the product is fully absorbed during use, add more. MC – Apply to the entire head slowly, moving upwards and outwards. Use with an oil-free conductive gel or a lightweight, oil-free skincare product for EMS. If the gel dries, reapply. DERMA SHOT – Apply to the entire head slowly, moving upwards and outwards. Hold in selected areas for 1–2 seconds. Always use with an oil-free conductive gel or a lightweight, oil-free skincare product. For best results, use the MC mode before applying the Derma Shot.
Safety instructions and warnings:
Clean after each use – wipe with a dry or slightly damp cloth with mild soap. Do not use if you have electronic implants. Avoid sensitive areas – do not use directly under the eyes, on the eyelids, or in the thyroid gland area. Around the eyes, nose, mouth – always use the lowest intensity. Consistency – best results are achieved with regular use according to the instructions. Do not use during pregnancy or while breastfeeding.