The iGET SECURITY P6 gas detector can work independently or can be wirelessly connected to the iGET SECURITY M2B system. This product provides comprehensive protection. The alarm sounds upon receipt of the signal and sends a warning SMS about it. Natural gas (LNG, CNG), carbon monoxide (CO, gas, coal gas, wood gas), LPG and petroleum substances can be detected. Once a given gas is detected, the warning diode starts blinking red and the detector siren starts. With the test button, you can check the functionality of the device.
Examples of places in the house, flat or cottage, where it is appropriate to place the gas detector:
Possible location for detecting gases that are lighter than air and rising:
Place the detector at a height of 15 to 30cm below the ceiling and60 cm from the corners from where the two walls converge. It must be a minimum of 1.2m from the source of gases to prevent false alarms.
Product can detect:
Possible location for detecting gases heavier than air and falling to the ground:
Position the detector at a height of 15 to 30cm above the ground and 60cm from the corners, ie from the places where the two walls converge. It must be at a minimum of 1.2m from the source of gases to prevent false alarms.
Product can detect:
Parameters and Specifications:
Transmission frequency: 433MHz
Used coding: 2262/1527
Operating temperature: +10° C ~ +50° C
Operating humidity: 20% ~ 90%
Environment: dry, internal
Supply voltage: 230V, 50 ~ 60Hz
Consumption: 2 ~ 3W
Siren: 90dB
Reaction: approx. 60 seconds
Sensitivity:
Coal gas: 2 ~ 5% LEL
Natural gas: 10 ~ 25% LEL
Propane butane: 10 ~ 25% LEL
(LEL = Lower Explosion Limit)
Signal range to the central unit:
Up to 50 meters. In direct visibility
Code: | NU105l |
Warranty: | 24 months |
Product Number: | P6 SECURITY |