FIBARO Dimmer 2

Dimmer 2

Wireless sensing and mood lighting switch.

Key features:

• Automatic light source detection
• Energy performance measurement function
• Compatible with two-wire or three-wire distribution
• Supports both the leading and trailing edges
• New Z-Wave 500 chip
• Z-Wave Plus protocol

Key features:

• Built-in scene activation
• Security and Notification
• Configuration menu with LEDs
• Certification DEKRA and Z-Wave
• Maximum power 250W

Intelligent detection

A specially designed algorithm recognises what kind of light source it is.
It sets optimal values accordingly. 

Compatible with both twin and triangular wiring

Dimmer 2 is designed for both 2-wire and 3-wire versions.
It can also be used in old electrical wiring.

Performance measurement

You have clear data on electricity consumption.
This information can be used to reduce electricity costs.

Control

Dimmer 2 is the first device on the market to provide control
both on the ascending and the descending edge. You have full control over
all kinds of light sources.

Set as needed

Dimmer 2 can be used to create diverse scenes. Imagine you wake up in the middle of the night
to go to the kitchen or toilet, but you turn on lights and you are blinded. With Dimmer 2 your
lights will illuminate at a preset value.

Scene management

Dimmer 2 offers intuitive scene management, which can be started by pressing the light switch. 

Smart Notification

Dimmer 2 is equipped with overvoltage protection, overvoltage or voltage drop protection.
If a problem occurs, it will send you a device status notification.

Easy to install

Dimmer 2 is made with larger diameter sockets that allow the use of wires
With a larger cross-section, and speed installation for devices.

Friendly configurations

The built-in RGB diode indicates device status information. You have an overview informing you whether a device is correctly connected to the network. The calibration, updates and signal range of the Z-Wave network is also displayed.

Z-Wave tester

Dimmer 2 can be used to verify the signal strength of the Z-Wave network. You can view the built-in RGB diode
for an ideal place to install the device. This avoids problems with connection to the Z-Wave network.

Software that is always up-to-date.

Device software is continually updated. You will always have, at your disposal,
the latest version of the system with new features.

You are only limited by your imagination

Dimmer 2 is a revolutionary lighting control tool. It recognises innovative technologies
Connected light source and set optimal values. Offers new possibilities
Z-Wave chip 500 along with the Z-Wave Plus protocol. You can adapt your household to your ideas while saving on electricity bills by monitoring your electricity consumption.