ELIZ EURO 121

The EURO 121 electric pressure water heater with dry ceramic heating element is the ideal solution for hard water areas. The dry ceramic heating element is not immersed in water, but stored in the metal housing of the flange, so there is no rapid scaling of the element. It is suitable for single or multiple tapping points and designed for vertical wall mounting.

Low heat loss and low operating costs

The water heater tank is made of high quality steel protected by a layer of zirconium enamel. High-quality CFC-free polyurethane insulation with a thickness of 33 mm guarantees low heat loss and cost savings for water heating. Use the thermostat located on the control panel to adjust the water temperature in the range of 7-75°C, with the option of setting the ECO mode. When set in ECO mode, the water is heated to the optimum temperature of 55 °Cwith reduced heat loss and lower power consumption . The minimum thermostat value serves as protection against water freezing in the heater. The heater has two built-in anode rods, which guarantee effective protection of the tank against corrosion and significantly extend its service life. A switch with a heater light is used to switch the heater on/off in our absence, which allows energy saving.
Additional information:
Tension:
230 V
Insurance:
10 A
Electrical protection:
IP 24
Water heating time from 12 °C to 65 °C:
3.8 hours.
Insulation thickness:
33mm
Water connection:
G 1/2''
Maximum water pressure:
6 bar
Weight:
35 kg