AXAGO RSC-C1

This adapter for Compact Flash cards enables high-speed connection of the Compact Flash memory card via the SATA interface. Combined with a fast CF card, it is suitable for replacing a disk drive in home multimedia computers, as well as in industrial computers, routers, and more.
The embedded CF card acts as a full-featured hard drive, including booting the operating system. For the next run, the adapter does not need any driver installation. The package contains a standard plug for attaching the controller to the rear of the PC.
Interface:
1 x SATA / 300 port for connection to the PC's SATA motherboard.
1 x Compact Flash slot for I/II and MicroDrive cards.
Properties:
Supports Compact Flash PIO modes and Ultra DMA 133MB/sec.
Powered by a standard 4-pin FDD power connector from the PC's PSU.
Adjustable power of the Compact Flash cards 3.3V or 5V.
Three LEDs to indicate the Compact Flash card connection, power supply and data transfer.
More information:
Ability to change CF cards while running is not supported.
Board dimensions 70 x 64mm (except for blanking).
Used chipset - Marvell 88SA8052.
Supported Operating Systems:
MS Windows all versions, DOS, Mac OS all versions, Linux all versions.
There is no need to install any external drivers, compatibility is not dependent on the operating system used, it is a pure hardware converter.
Package contains:
SATA-CF adapter with standard PC slot plug, 50cm SATA cable, 20cm power cable 4pin Molex male 4pin Molex female + 4pin FDD power female, "Velcro fastener" for alternate adapter mounting without a blank and printed installation instructions in English, Czech, Slovak and Polish.